Doll House (Back Part) only

0 ratings

This product is for the back part of the house with chimney.

It can be connected to switch for light.

You can find Full house file in my another listing.

I printed in 200 micron layers.

You may print the last layer of the floors in "Concentric" to achieve the effect shown in the picture.

Do rotate the file for optimize printing.

All walls have raft build in, do remove them before assembly.

Support needed, but you might minimize the support if you set the support angle at 60 degree

Will require printer with 300x300 (XY) print area.

Parts required superglue. Pegs are designed for optimize assembly.

It is good to have a M3 tap for tapping the thread for fixing the chimney.

The middle floor expansion can be downloaded from:

  • Size
    420 KB
  • Size420 KB
Powered by


Doll House (Back Part) only

Enter your info to complete your purchase


You'll be charged US$8.99.